Safety Tests

Additional Resources

Teacher Resources

Contact Info

Drill Press Safety Test

Using the drop down menus, select the correct part name that each arrow is pointing to on the machine. Be sure to select a name for each part. Do not use the same part name twice.






Read each statement carefully and decide if it is True or False. Be sure to answer all questions. When finished, enter your FIRST AND LAST NAME along with your teacher's email address and click the submit button.

6. Square drill bits can be used.

7. Center punch all holes to be drilled.

8. Use your fingers to tighten the chuck.

9. Remove the chuck key before turning on the Drill Press.

10. Clamp material to the table before drilling.

11. Force the drill bit through the material.

12. Do not drill into the drill press table.

13. Back up stock to avoid splintering.

14. The depth stop does not need to be checked before drilling.

15. Remove the drill bit after drilling when it is hot.

Read the following information, check the I agree box, fill in your name and instructor's email, then click the submit button to send the test score to your instructor.

I acknowledge that by submitting this form I am confirming that I am the person who's name is entered below. I further acknowledge that I did not use any resources or receive any assistance during the completion of this test.

I Agree

Your name:

Instructor's email:

Created by Tyler S. Love

Copyright © 2000/2006/2014 by the International Technology and Engineering Educators Association. All rights reserved. Except as permitted under the United States Copyright Act of 1976, no part of this publication may be reproduced or distributed in any form or by any means, or stored in a database or retrieval system without the prior written permission of the publisher.